无后坐控爆拆除砖砌水塔的实践

介绍了对一砖砌水塔进行无后坐拆除爆破时爆破参数的选取,以及控制后坐的措施.实践证明:用控制爆破方法,选择合理的爆破参数完全可以控制水塔在倾倒时的后坐.     

80m高钢筋砼烟囱的爆破拆除

论述了控制爆破拆除钢筋砼烟囱的方案设计与力学计算、爆破参数确定、施工方法、安全防护措施、震动监测和爆破效果.     

塔楼与桅杆的风效应影响

本文通过对广播电视塔上的塔楼及桅杆结构的模拟计算和对比分析，探讨了两者之间风效应的相互影响及有关问题。     

三峡工程钢管槽爆破开挖技术研究

 三峡钢管槽由于其地理位置和地质条件特殊，必须采取非常严格的控制爆破技术和手段，才能保证其成型质量和围岩稳定。介绍了长江科学院就此进行的现场爆破试验研究成果以及实际规模开挖时所采取的控制开挖程序、锚杆支护等技术措施。这些研究成果和技术措施有力地保证了钢管槽的开挖质量。     

液相添加剂对PTCR陶瓷电性能的影响

液相添加剂ＡＳＴ（Ａｌ２Ｏ３＋ＳｉＯ２＋ＴｉＯ２）对ＢａＴｉＯ３陶瓷材料电性能的影响很大，随着Ａｌ２Ｏ３含量的增加，材料的电性能降低；ＳｉＯ２、ＴｉＯ２的物理特性对材料电性能影响较大；过量ＴｉＯ２对材料ＰＴＣ效应有重要影响，适当过量ＴｉＯ２含量，可得到性能优良的ＰＴＣＲ陶瓷。     

某微型起爆器引起的一起误爆事故分析

该文分析某微型起爆器引起的一起误爆事故，指出该起爆器设计上的缺陷及其对作业安全的威胁，提出防患建议。     

块状岩体台阶爆破炮孔填塞作用的研究

本文利用电磁测量法及高速摄影法对块状模型中炮孔填塞物在孔内的运动规律和块体移动过程进行了研究。根据模拟试验及一些生产爆破的观测结果，对炮孔填塞机理提出了一些新的观点；同时就露天矿台阶爆破炮孔填塞长度及材料对爆破效果的影响作了简要分析。     

Tc trend in high-Tc superconductors

In our previous works, we have shown that most existing ceramic superconductors can be considered to be built of superconductor-semiconductor composite and we have estimated the change in phonon spectrum of the intrinsic superconductor unit if a semiconductor unit is attached to it. Moreover, the proximity effect under the size quantization condition has been examined in the superconductor-semiconductor composite. Each of the stated effects by itself could causeT _c enhancement in general as more semiconductor blocks are added to the system. We extend our study in this paper to analyze the combined actions of phonon spectral change and proximity effect without size quantization condition onT _c variation in members of the Tl₁ series of high-T _c superconductors. Our results indicate that an optimumT _c is obtained if the stated effects are included in the idealized unit cells of the superconductors made up of a superconductor-semiconductor array.     

Effect of Bi and Sr concentrations on the formation of the 2223 phase in Bi-Pb-Sb-Sr-Ca-Cu-O materials, obtained under different conditions of thermal treatment

The superconducting properties and the phase and chemical composition of Bi _x Pb_0.3Sb_0.1Sr _y Ca₂Cu₃O_z (x=1.5, 1.6, and 1.7;y=1.9, 2.0, and 2.1) materials synthesized by one-step and multistep thermal treatments have been investigated. The multistep annealing between 825–875°C promotes the 2223 phase. The change of Bi concentration has little effect on the 2223 phase formation, regardless of the kind of thermal treatment used, but increasing the Sr concentration (y> 2) strongly inhibits this phase. It has also been established that the loss of Pb after synthesis depends on the initial Bi concentration. The loss of Pb decreases when the initial Bi content is lower.